HP ProLiant DL160 Gen8, User Manual, Page: 19 / 111

Operations 19
4.
Extend the server from the rack (on page 17 ).
5.
Release the locking latches.
6.
Disconnect the cabling, and then remove the server from the rack. For more information, see the
documentation that ships with the rack mounting option.
7.
Place the server on a sturdy, level surface.
Remove the access panel
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: Do not operate the server for long periods with the access panel open or removed.
Operating the server in this manner results in improper airflow and improper cooling that can
lead to thermal damage.
To remove the component:
1.
If installed, remove the rack bezel (on page 59 ).
2.
Power down the server (on page 17 ).
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Extend the server from the rack (on page 17 ).
5.
Open the locking latch, slide the access panel to the rear of the chassis, and remove the access panel.
If the locking latch is locked use a T-15 Torx screwdriver to unlock the latch.
Install the access panel
1.
Place the access panel on top of the server with the hood latch open. Allow the panel to extend past the
rear of the server approximately 1.25 cm (0.5 in).
2.
Push down on the hood latch. The access panel slides to a closed position.
3.
Use the T-15 Torx screwdriver provided with the server to tighten the security screw on the hood latch.
Remove the processor air baffle
1.
If installed, remove the rack bezel (on page 59 ).
2.
Power down the server (on page 17 ).
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Extend the server from the rack (on page 17 ).
5.
Remove the access panel (on page 19 ).