Removal and replacement procedures 48
CAUTION:
When returning a damaged system board to HP, always install all processor socket
covers to prevent damage to the processor sockets and system board.
To remove the component:
1.
Power down the server blade (on page
23
).
2.
Remove the server blade (on page
24
).
3.
Place the server blade on a flat, level work surface.
4.
Remove the access panel ("
Access panel
" on page
26
).
5.
Remove all drives ("
Drive
" on page
27
).
6.
Remove all drive blanks ("
Drive blank
" on page
27
).
7.
Remove the mezzanine assembly ("
Mezzanine assembly
" on page
29
).
8.
Remove the FlexibleLOM ("
FlexibleLOM
" on page
32
).
9.
Do one of the following:
o
Remove the storage controller ("
Storage controller
" on page
33
)
o
Disconnect the direct connect SATA cable ("
Direct connect SATA cabling
" on page
71
).
10.
Remove the internal USB drive, if installed. To locate the internal USB connector, see "System board
components (on page
66
)."
11.
Remove the microSD card, if installed. To locate the microSD card, see "System board components (on
page
66
)."
12.
Remove all DIMM baffles ("
DIMM baffles
" on page
35
).
13.
Remove all DIMMs ("
DIMMs
" on page
37
).
14.
Extend the serial label pull tab.
