HP procurve switch xl modules, Installation Manual

Page: 23 / 48

17
HP ProCurve Switch xl Modules
Installing the Modules
Verifying the Module is Installed Correctly
Observe the Module Status LED for the slot in which the module is being
installed, and the Self Test and Fault LEDs on the switch to verify the module
is installed properly.
When the module is installed properly and the switch is powered on, or
the module is installed when the switch already has power, the module
undergoes a self test that takes a few seconds. You can use the LEDs to
determine that the module is installed properly and has passed the self
test, as described in the “LED Behavior” table below.
LED Behavior
Power Fan
Status
Self
Test
Clear Reset
Console
Modules LED Mode Select
hp procurve
switch 5304xl
Max
J4820A
Use xl modules only
J4850A
xl module
xl
J4820A
xl module
procurve procurve
!
FDx Act D C B A 2 1
A
C
Self Test
Module Status LEDs Fault LED
Module Link and Mode
LEDs
LED Display for a Properly Installed Module
Module Status (for the slot in which you are installing the module) The LED
goes ON as soon as the module is installed and the switch is
powered on, and stays ON steadily.
Self Test ON briefly while the module is being tested, then OFF.
Note: If the switch was powered off while the module was
installed, when the switch is powered on, the Self Test LED
will stay ON for the duration of the whole switch self test.
Fault OFF
Link and Mode (on
the modules) For a module that is installed when the switch is already
powered on (hotswap), all the Link and Mode LEDs on the
module go ON for approximately 3 to 10 seconds, then OFF
for 5 to 10 seconds depending on the module. Then, the Self
Test LED on the switch goes OFF.
If the module is already installed when the switch is powered
on or reset, the process described above occurs approxi-
mately 30 seconds after the power on or reset, during which
the switch is being tested.