HP ProCurve Series 2810, Management And Configuration Manual

Page: 181 / 420

Port Status and Basic Configuration
Overview
Overview
Note On Connecting
Transceivers to
Fixed-Configuration
Devices
This chapter describes how to view the current port configuration and how
to configure ports to non-default settings, including
■
Enable/Disable
■ Mode (speed and duplex)
■
Flow Control
■ Broadcast Limit
■
Auto-MDIX
■ Jumbo Packets
■
QoS Pass-Through Mode
■ Configuring Port-Based Priority for Incoming Packets
■
Using Friendly (Optional) Port Names
Viewing Port Status and Configuring
Port Parameters
Port Status and Configuration Features
Feature Default Menu CLI Web
viewing port status n/a page 10-5 page 10-7 page 10-15
configuring ports See Table 10-1 page 10-6 page 10-10 page 10-15
on pages 10-4
and 10-4.
If the switch either fails to show a link between an installed transceiver and
another device, or demonstrates errors or other unexpected behavior on the
link, check the port configuration on both devices for a speed and/or duplex
(mode) mismatch. To check the mode setting for a port on the switch, use
either the Port Status screen in the menu interface (page 10-5) or
show
interfaces brief in the CLI (page 10-7).
10-3