HP ProCurve 8116fl, Installation And Getting Started Manual

Page: 27 / 134

2
Installing the ProCurve Switch 8100fl
This chapter describes how to install a ProCurve Switch 8100fl. The
illustrations in this chapter show the 8-slot Switch 8108fl—unless otherwise
indicated, the same procedures apply to both the Switch 8108fl and the 16-slot
Switch 8116fl.
W A R N I N G
To avoid possible personal injury, be careful when lifting the chassis out of
the shipping box. The Switch 8108fl chassis weighs approximately 130lbs as
shipped and 94 lbs when empty; the Switch 8116fl chassis weighs over 200lbs
as shipped and 137 lbs when empty. See
“Installation Guidelines” on page 2-5
for additional safety considerations when handling this product.
Parts and Part Numbers
N o t e
The following components are the same in both the Switch 8108fl and the
Switch 8116fl:
■
Power supplies
■ Fan trays
■
Management module
■ Interface modules
The switch fabric modules, however, are different in each model.
Switch 8108fl (J8727A)
The ProCurve Switch 8108fl is shipped in several containers with the following
components:
■ 8-slot chassis (J8727A) with blank slot covers for vacant slots (see page
2-29 for slot cover part numbers) and blank power supplies (1530-2431)
■ One ProCurve Switch fl Redundant Management Module (J8731A)
■ One ProCurve Switch 8108fl Redundant Switch Fabric Module (J8729A)
■ One ProCurve Switch fl Redundant Power Supply (J8732A)
Inst
all
ing t
he Pro
C
u
rve
Switch 8
100fl
2-1