Configuring RADIUS Server Support for Switch Services
Configuring and Using RADIUS-Assigned Access Control Lists
Elements in a RADIUS-assigned ACL Configuration.
A RADIUS-
assigned ACL configuration in a RADIUS server has the following elements:
■
vendor and ACL identifiers:
•
ProCurve (HP) Vendor-Specific ID: 11
•
Vendor-Specific Attribute for ACLs: 61 (string = HP-IP-FILTER-RAW)
•
Setting: HP-IP-FILTER-RAW = < “permit” or “deny” ACE >
(Note that the “string” value and the “Setting” specifier are identical.)
■
ACL configuration, including:
•
one or more explicit “permit” and/or “deny” ACEs created by the
system operator
•
implicit deny any any ACE automatically active after the last operator-
created ACE
Nas-Filter-Rule-Options
Table 6-4.
Nas-Filter-Rule Attribute Options
Service
Control Method and Operating Notes:
ACLs Applied to Client
Traffic Inbound to the
Switch
Assigns a RADIUS-
configured ACL to
filter inbound packets
received from a
specific client
authenticated on a
switch port.
Standard Attribute: 92
This is the preferred attribute for use in RADIUS-assigned ACLs to configure ACEs to filter IPv4
traffic.
Entry for IPv4-Only ACE To Filter Client Traffic:
Nas-filter-Rule = “<
permit or deny ACE
>” (Standard Attribute 92)
For example:
Nas-filter-Rule=”permit in tcp from any to any”
ACLs Applied to Client
Traffic Inbound to the
Switch
Assigns a RADIUS-
configured IPv4 ACL
to filter inbound IPv4
packets received from
a specific client
authenticated on a
switch port.
HP-Nas-Filter-Rule (Vendor-Specific Attribute): 61
This attribute is maintained for legacy purposes to support ACEs in RADIUS-assigned ACLs.
However, for new or updated configurations HP recommends using the Standard Attribute (92)
described earlier in this table instead of the HP-Nas-filter-Rule attribute described here.
HP (ProCurve) vendor-specific ID: 11
VSA: 61 (string = HP-Nas-Filter-Rule
Setting:
HP-Nas-filter-Rule = “<
permit or deny ACE
>”
6-18
Summary of Contents for PROCURVE 2910AL
