HP ProCurve 2810-24G, Management And Configuration Manual

Page: 69 / 272

3-11
GVRP
Introduction
4. Determine security boundaries and how the individual ports in the seg-
ment will handle dynamic VLAN advertisements. (See table 3-1 on page
3-7 and table 3-2 on page 3-8.)
5. Enable GVRP on all devices you want to use with dynamic VLANs and
configure the appropriate “Unknown VLAN” parameter (
Learn
,
Block
, or
Disable
) for each port.
6. Configure the static VLANs on the switch(es) where they are needed,
along with the per-VLAN parameters (
Tagged
,
Untagged
,
Auto
, and
Forbid
—
see table 3-2 on page 3-8) on each port.
7. Dynamic VLANs will then appear automatically, according to the config-
uration options you have chosen.
8. Convert dynamic VLANs to static VLANs where you want dynamic VLANs
to become permanent.
Configuring GVRP On a Switch
The procedures in this section describe how to:
■ View the GVRP configuration on a switch
■ Enable and disable GVRP on a switch
■ Specify how individual ports will handle advertisements
To view or configure static VLANs for GVRP operation, refer to “Per-Port Static
VLAN Configuration Options” on page 2-8.