12
The switch Link LED for the transceiver port is blinking.
This
condition occurs on the Series 2300 and 2500 switches. After installing the
transceiver, these switches must be reset or rebooted to initialize the
transceiver. The flashing LED tells you that the transceiver is not operational
until the switch is reset or rebooted.
The switch Fault LED and Link LED for the transceiver port are
blinking.
The transceiver may not be installed correctly, or may be faulty.
Disconnect power from the networking device and reinstall the transceiver
into the module or networking device. Verify the transceiver screws are
tightened. Turn the device power back on, and if the flashing persists, the
transceiver may be faulty.
For additional troubleshooting, you can also use the device's console interface, the
switch’s web browser interface, or HP Top Tools for Hubs & Switches to trouble-
shoot and configure the High-Speed Transceiver port. See the switch's
Management
and Configuration Guide
for more information. If you are still having trouble, see
the “Customer Support Services” below.
Customer Support Services
If you are having any trouble with your transceiver, Hewlett-Packard offers
support 24 hours a day, seven days a week through the use of a number of
automated electronic services. See the Customer Support/Warranty booklet
that came with your transceiver for information on how to use these services
to get technical support. The HP networking products World Wide Web site,
http://www.hp.com/go/hpprocurve
also provides up-to-date support infor-
mation and contact phone numbers. Click on the
button on
that web page.
Additionally, your HP-authorized network reseller can also provide you with
assistance, both with services that they offer and with services offered by
HP.
xcvrs_3-2002.fm Page 12 Tuesday, April 2, 2002 3:23 PM
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com