Power connector cable
NOTE:
The power connector cable is included in the Cable Kit, spare part number 639473-001.
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
b.
Optical drive (see
)
c.
Keyboard (see
d.
)
e.
Fan (see
)
f.
Heat sink (see
g.
Base enclosure cover (see
Base enclosure cover on page 82
h.
)
i.
System board (see
Remove the power connector cable:
1.
Position the top cover upside-down, with the front toward you.
2.
Lift the power connector up from the clips in the rear of the base enclosure.
Component replacement procedures
107