Installing the Fibre Loop Switch
15
Figure 6: Mounting in HP Rack System/E and HP Rack System/U Racks
Tools Required
To install the switch in an HP rack, you need a T25 Torx driver and a #1 Phillips-
head screwdriver.
HP Rack Mounting Installation Steps
Installing the fibre loop switch into an HP rack requires the following general
steps:
•
Step 1: Preparation
•
Step 2: Mark the Rack Column Holes
•
Step 3: Place the Barrel Nuts on the Rack Columns
• Also install the “L” and “R” spacers on the front columns of HP Rack
System/E and HP Rack System/U racks only.
Left Front
Rack Column
Left Rear Rack Column
Rails
Switch
Right Front Rack Column
Sleeves
Right Rear Rack Column
"L" Spacer
"R" Spacer
Summary of Contents for P4459A
Page 16: ...8 HP P4459A 8 Port Fibre Loop Switch Installation Operation Guide ...
Page 44: ...36 HP P4459A 8 Port Fibre Loop Switch Installation Operation Guide ...
Page 48: ...40 HP P4459A 8 Port Fibre Loop Switch Installation Operation Guide ...
Page 60: ...52 HP P4459A 8 Port Fibre Loop Switch Installation Operation Guide ...