HP Open View, Installation And Maintenance Manual

Page: 39 / 184

Completing the Appliance Setup
39 Continuous Access Storage Appliance Installation and Maintenance Guide
Manually configuring port access
To manually configure port access:
1. Ensure the hp OV CASA Console window is open in administrative mode.
2. Click switchui to open the Windows NT desktop. See “ Using switchui ” on page 28 for
instructions.
3. Click Start > Settings > Control Panel.
The Control Panel window opens.
4. Click Network.
The Network dialog box opens ( Figure 7 ).
5. Click the Protocols tab, click TCP/IP Protocol, and then click Properties.
The Microsoft TCP/IP Properties dialog box opens ( Figure 8 ).
6. Select the LAN Interface adapter in the Adapter list and click Advanced.
The Advanced IP Addressing dialog box opens ( Figure 9 ).
7. Click the Enable Security check box, which enables the Configure button.
8. Click Configure.
The TCP/IP Security dialog box opens ( Figure 10 ).
9. Add and set access to the specific ports, using the information in Table 3 .
Figure 7: Network dialog box