22
HP Netserver High Density Rack Solutions Overview (LP 2000r)
3. Slide mounting
Use the HP J1480A, 2-Post Slide Mount Adapter. Attaching the slides is a tool-less procedure.
Marking the Rack
The HP Netserver LP 2000r rack mount kit requires two EIA units of space in the rack. Use this section to
mark the columns of the 2-post non-HP rack. The brackets attach to the front side of the two columns for
either flush mount or center mount brackets. The masking tape (or marking pen) is used to identify and
mark the locations on the columns.
CAUTION
If other rack components are to be mounted in the rack below the HP Netserver,
install those components before starting to mount the Netserver.
NOTE
Use the
HP Rack Configuration Tools
to determine where in the rack to mount the HP
Netserver. The tools are available at:
h t t p : / / w w w. h p . c o m / n e t s e rv e r / s u p p o rt
1. Use the mounting brackets to help find the Netserver location on the columns, as shown in figure below.
The screw holes cover a span of only one EIA unit, which is the height requirement of the HP Netserver.
2. Use the masking tape (or marking pen) to mark above the 3rd hole up the on face of both front
columns, as shown in figure below.
NOTE
The brackets use the 1st and 5th holes on the respective front columns, regardless of the
mounting position.
Location Marks on the Rack's Front Columns
