HP msm3 series, Installation And Getting Started Manual

Page: 103 / 132

MSM335
Initial configuration (autonomous mode)
8-9
7. Verify that the MSM335 is firmly anchored before letting go of it.
Installing in a plenum
See Plenum installation under Installing in a plenum on page 8-9 .
Antenna position
The antenna flaps can be adjusted to optimize radio performance. Start with the following
positions, then adjust as needed. (See also the MSM335 Antenna Technical Note .)
 For wall mount, close or fully open the flaps.
 For ceiling mount, close the flaps or point them toward the floor (90
o
).
Powering the MSM335
The MSM335 can be powered by:
 A 10/100 or 10/100/1000 PoE-enabled switch. Various PoE-enabled switches are available
from HP.
 An HP 1-Port Power Injector (J9407A)
 An HP MSM335 Power Supply (J9406A).
Caution
If the MSM335 will be powered by a user-supplied PoE power injector, use only a gigabit-
compatible power injector. PoE injectors designed for 10/100 networks only are NOT
compatible with the MSM335.
Initial configuration (autonomous mode)
This procedure describes how to switch a factory-default MSM422 to autonomous mode and
then perform its initial configuration that enables you to establish a wireless connection
through the MSM335 to the Internet.
In autonomous mode, the MSM335 is managed via its Web-based management tool as
described in this section. This requires at least Microsoft Internet Explorer 7/8 or Mozilla
Firefox 3. x .
For controlled mode configuration, see
Working with controlled APs
in the
MSM7xx
Controllers Management and Configuration Guide
.