Controller enclosure—rear panel layout
13
MSA 2050 SAN controller module—rear panel components
shows host ports configured with either 8/16 Gb FC or 10GbE iSCSI SFPs. The SFPs look identical. Refer to the
LEDs that apply to the specific configuration of your Converged Network Controller ports.
Figure 5 MSA 2050 SAN controller module face plate (FC or 10GbE iSCSI)
shows Converged Network Controller ports configured with 1 Gb RJ-45 SFPs.
Figure 6 MSA 2050 SAN controller module face plate (1 Gb RJ-45)
NOTE:
For more information about host port configuration, see the topic about configuring host ports within the SMU
Reference Guide or online help.
1
Host ports: used for host connection or replication
[see
“Install an SFP transceiver” (page 77)
]
2
CLI port (USB - Type B)
3
Service port 2 (used by service personnel only)
4
Reserved for future use
5
Network port
6
Service port 1 (used by service personnel only)
7
Disabled button (used by engineering only)
(Sticker shown covering the opening)
8
SAS expansion port
1
Host ports: used for host connection or replication
[see
“Install an SFP transceiver” (page 77)
]
2
CLI port (USB - Type B)
3
Service port 2 (used by service personnel only)
4
Reserved for future use
5
Network port
6
Service port 1 (used by service personnel only)
7
Disabled button (used by engineering only)
(Sticker shown covering the opening)
8
SAS expansion port
1
5
7
3 4
6
8
2
= FC LEDs
= 10GbE iSCSI LEDs
= 1 Gb iSCSI LEDs (all host ports use 1 Gb RJ-45 SFPs in this figure)
1
5
7
3 4
6
8
2
= FC LEDs