HP ML350 - ProLiant - G2, Maintenance And Service Manual

Page: 34 / 78

Removal and replacement procedures 34
4.
Remove the air baffle.
To replace the component, reverse the removal procedure.
System fans
CAUTION: The system fan is a non-hot-pluggable device.
Fan failures are indicated by amber LEDs located on each hot-plug fan and by the front panel internal
health LED. When a fan failure occurs, the internal health LED illuminates red in non-redundant mode and
amber in redundant mode.
To remove the component:
1.
Power down the server (on page 26 ).
2.
Do one of the following:
•
Unlock and remove the bezel (" Front bezel " on page 27 ).
•
Extend the server from the rack (on page 26 ).
3.
Remove the access panel (" Access panel " on page 29 ).
4.
Remove the air baffle (" Air baffle " on page 33 ).
5.
Disconnect the system fan cable from the system board (" System board components " on page 64 ).