English
English
21
HP L1510 15” LCD Monitor
Using Your Monitor
To access the
Recall
function, first select
Information
, then select
Recall
from the sub-menu
WARNING
By pressing the
button all previous adjustments are lost (refer to
“Adjusting Your Monitor” on page 10 to adjust the monitor again).
Setting the Amount of Displayed Information
To set the amount of displayed information, change the screen resolution
of your computer. The higher the screen resolution, the more information
you can see on the screen. It is recommended that you use a resolution of
1024 x 768. It is recommended that you use a refresh rate of 60 Hz. The
image refresh rate is the number of times per second that the image is
redrawn.
NOTE
LCD technology does not cause any flicker at low refresh rates.
Minimizing Energy Consumption
If your computer supports VESA monitor power management (available
on many HP computers), you can minimize the power consumed by the
monitor. There are two power saving modes:
•
Suspend mode (uses less than 5W)
•
Sleep mode (uses less than 5W)
When the monitor enters power saving mode, the message No Signal is
displayed for a few seconds before the screen blanks. In power saving
mode the front panel indicator light is amber.
To set these power saving modes, refer to the manual that came with your
computer.
Recall
: If you press
, factory preset
settings will be recalled. The settings that are
affected by the
Recall
function are
•
Screen Geometry
•
Horizontal Frequency
•
Vertical Frequency
•
Brightness / Contrast
RECALL
EXIT