Figure 27 A 5-Wire Connector
To install the PDCA, follow these steps:
WARNING!
Make sure the circuit breaker on the PDCA is
OFF
.
1.
Remove the rear PDCA bezel by removing the four retaining screws.
2.
Run the power cord down through the appropriate opening in the floor tile.
3.
Insert the PDCA into its slot (
Figure 28 (page 33)
).
Figure 28 Installing the PDCA
4.
Using a T-20 driver, attach the four screws that hold the PDCA in place.
5.
If required, repeat step 2 through step 4 for the second PDCA.
Setting Up the System
33
Summary of Contents for Integrity Superdome sx2000
Page 14: ...14 Installing the System ...
