NOTE:
The bottom piece of the pedestal is taller than the server, so try to position the server
so the right side (in the horizontal position) of the server hangs off the edge of the work surface
by a few inches to allow the bottom piece to be attached to the server chassis. If that is not possible,
then raise up the server approximately 3 inches from the work surface to allow the pedestal kit
bottom piece to be attached to the server left side.
To attach the components.
1.
Align the holes in the pedestal component with the posts on the server. See
NOTE:
One of the holes in the pedestal component contains the locking mechanism. This
makes the hole appear partially blocked.
2.
Hold the pedestal component flush against the server.
3.
Slide the pedestal component forward until it locks into place
Figure 2-3 Installing the pedestal bottom piece
4.
Stand the server up on the bottom piece of the pedestal kit that was just installed so the
server is in the vertical position.
CAUTION:
The server is heavy. Be careful when lifting it to the vertical position.
Without the feet installed, the server may tip over easily. Be careful when working near the
server to avoid tipping it over.
5.
Align the holes in the pedestal top piece with the posts on the server.
NOTE:
One of the holes in the pedestal component contains the locking mechanism. This
makes the hole appear partially blocked.
6.
Hold the pedestal top piece flush against the server.
7.
Slide the pedestal top piece forward until it locks into place.
8.
The top and bottom pedestal kit pieces are now in place.
Attach the pedestal kit top and bottom
11
