6 Using the touch screen
EN
2
To switch between standby and ready modes, touch either Standby On/Off or
Ready On/Off.
3
When the rewinder is in standby mode, you can do the following tasks from the first
Operator screen:
• To raise the right clamp and close the nip cassette, touch the right Up Clamp
button.
• To lower the right clamp and open the nip cassette, touch the right Down Clamp
button.
• To raise the left clamp, touch the left Up Clamp button.
• To lower the left clamp, touch the left Down Clamp button.
• To deflate the rewinder spindle, touch Air off Spindle.
• To inflate the rewinder spindle, touch Air on Spindle.
• To change the rewinder direction, touch
.
• To slowly turn the rewinder spindle, touch and hold
. To stop turning the rewinder
spindle, release
.
4
Touch .
The
second
Operator screen appears.
5
When the rewinder is in standby mode, you can do the following tasks from the
second Operator screen:
• To enable dancer arm tension, touch High Tension.
• To disable dancer arm tension, touch Low Tension.
6
When the rewinder is in ready mode, you can do the following tasks from the second
Operator screen:
• To start printing, touch PE Print two times. Ensure that the press and the web
handling system are both in the ready mode.
• To stop printing, touch PE Stop.
• To feed the web, touch PE Feed two times. Hold PE Feed until the correct amount
of substrate is fed. Ensure that the web handling system is in the ready mode.
Figure 1-7. Second Operator screen
