HP HPE ProLiant DX360 Gen10, User Manual

Page: 65 / 187

9. Install the access panel ( Install the access panel).
10. Slide the server into the rack.
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server (Power up the server).
Drive options
Depending on the configuration, this server supports SAS, SATA, NVMe, and uFF M.2 drives. For more information on
drive support, see
Device numbers.
When adding hard drives to the server, observe the following general guidelines:
• The system automatically sets all device numbers.
• If only one hard drive is used, install it in the bay with the lowest device number.
• Drives should be the same capacity to provide the greatest storage space efficiency when drives are grouped together
into the same drive array.
Hot-plug drive guidelines
When adding drives to the server, observe the following general guidelines:
• The system automatically sets all device numbers.
• If only one drive is used, install it in the bay with the lowest device number.
• Drives should be the same capacity to provide the greatest storage space efficiency when drives are grouped together
into the same drive array.
Removing the hard drive blank
Remove the component as indicated.
Hardware options installation
65