461
Configuring a PW
Configuring a PW class
In a PW class, you can configure PW attributes such as the PW type, and whether to enable control
word. To simplify PW configuration, you can configure PWs with the same attributes by referencing
the same PW class.
To configure a PW class:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create a PW class and enter
PW class view.
pw-class
class-name
By default, no PW class is
created.
3.
(Optional.) Enable control
word.
control-word enable
By default, control word is
disabled.
4.
(Optional.) Specify the PW
type.
pw-type
{
ethernet
|
vlan
}
By default, the PW type is VLAN.
Configuring a static PW
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter VSI view.
vsi
vsi-name
[
hub-spoke
]
N/A
3.
Specify static signaling
for PWs, and enter VSI
static view.
pwsignaling
static
By default, no PW signaling protocol is
specified.
4.
Configure a static PW,
and enter VSI static PW
view.
peer
ip-address
[
pw-id
pw-id
]
in-label
label-value
out-label
label-value
[
hub
|
no-split-horizon
|
pw-class
class-name
|
tunnel-policy
tunnel-policy-name
] *
By default, no static PW is configured.
If both a default PW ID in the
default-pw-id
command and a PW ID in the
peer
command are configured, the PW ID in the
peer
command is used. If only a default PW
ID is configured, the default PW ID is used. If
no default PW ID is configured, you must
provide a PW ID in the
peer
command.
If a VSI is enabled with the hub-spoke
capability (the
hub-spoke
keyword in the
vsi
command), PWs in the VSI are spoke links
by default. You can use the
hub
keyword in
this command to specify the static PW as the
hub link in the VSI.
You must specify the
no-split-horizon
keyword to disable split horizon when you
configure an NPE to establish a U-PW with a
UPE.
5.
Set the expected
bandwidth for the PW.
bandwidth
bandwidth-value
By default, the expected bandwidth is
10000000 kbps.
Summary of Contents for HPE FlexNetwork MSR Router Series
Page 10: ...viii Index 540 ...