HP HPE FlexNetwork 7500 series, Configuration Manual

Page: 424 / 592

412
Step Command Remarks
2. Enter RIPng view.
ripng [ process-id ]
[ vpn-instance
vpn-instance-name ]
N/A
3. Enable the zero field check
on incoming RIPng packets.
checkzero
By default, zero field check is
enabled for incoming RIPng
packets.
Setting the maximum number of ECMP routes
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIPng view.
ripng [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Set the maximum number
of ECMP routes.
maximum load-balancing
number
By default, the maximum number
of ECMP routes equals the
maximum number of ECMP
routes supported by the system.
Configuring the RIPng packet sending rate
Perform this task to specify the interval for sending RIPng packets and the maximum number of
RIPng packets that can be sent at each interval. This feature can avoid excessive RIPng packets
from affecting system performance and consuming too much bandwidth.
To configure the RIPng packet sending rate:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter RIPng view.
ripng [ process-id ]
[ vpn-instance
vpn-instance-name ]
N/A
3. Set the interval for sending
RIPng packets and the
maximum number of RIPng
packets that can be sent at
each interval.
output-delay time count count
By default, a RIPng process
sends a maximum of three RIPng
packets every 20 milliseconds.
4. Return to system view.
quit N/A
5. Enter interface view.
interface interface-type
interface-number
N/A
6. Set the interval for sending
RIPng packets and the
maximum number of RIPng
packets that can be sent at
each interval.
ripng output-delay time count
count
By default, an interface uses the
RIPng packet sending rate
configured for the RIPng process
that the interface runs.