8-44
1/10GBASE-T autosensing Ethernet port
An HPE 5944 48XGT 6QS28 switch provides forty-eight 1/10GBASE-T autosensing Ethernet ports.
Table8-12 1/10GBASE-T autosensing Ethernet port specifications
Item
Specification
Connector type
RJ-45
Port transmission rate, duplex
mode, and auto-MDIX
1/10 Gbps, full duplex, MDI/MDIX autosensing
Transmission medium and max
transmission distance
•
55 m (180.45 ft) over category-6 unshielded twisted pair cable
•
100 m (328.08 ft) over category-6 shielded twisted pair cable
•
100 m (328.08 ft) over category-6A or above twisted pair cable
Compatible standards
•
IEEE 802.3ab
•
IEEE 802.3an
To avoid interference between cables, layer cables as follows:
•
Use category-6A or above cables and connectors.
•
Do not bundle cables in their first 20 m (65.62 ft).
•
Separate power cords and twisted pair cables at and around the distribution frame.
•
For ports adjacent to one another on the device, the peer ports on the distribution frame are
preferably not adjacent, for example:
If the device connects to one distribution frame, connect port 1 on the device to port 1 on the
distribution frame, port 2 on the device to port 3 on the distribution frame, and port 3 on the
device to port 5 on the distribution frame.
If the device connects to two distribution frames, connect port 1 on the device to port 1 on
distribution frame 1, port 2 on the device to port 1 on distribution frame 2, and port 3 on the
device to port 2 on distribution frame 1.
LEDs
System status LED
The system status LED shows the operating status of the switch.
Table8-13 System status LED description
LED mark
Status
Description
SYS
Steady green
The switch is operating correctly.
Flashing green
The switch is performing power-on self test (POST).
Steady red
The system has failed POST, or a fault has occurred.
Flashing red
Some ports have failed POST.
Flashing blue (3 Hz)
Helps you to locate the device.
To locate the device, execute the
locator blink
command on
the device. Then the SYS LED will be in this state.
Off
The switch is powered off or has failed to start up.