
7-16
Configuring RADIUS Server Support for Switch Services
Configuring and Using Dynamic (RADIUS-Assigned) Access Control Lists
switch to filter IP traffic coming from outside the network, thus removing
unwanted IP traffic as soon as possible and helping to improve system
performance. Also, applying RADIUS-assigned ACLs to the network edge is
likely to be less complex than configuring static port and VLAN-based ACLs
in the network core to filter unwanted IP traffic that could have been filtered
at the edge.
N o t e
A RADIUS-assigned ACL filters inbound IP traffic on a given port from the
client whose authentication triggered the ACL assignment to the port.
A RADIUS-assigned ACL can be applied regardless of whether IP traffic on
the port is already being filtered by other, static ACLs that are already assigned.
Table 7-6 lists the supported per-port ACL assignment capacity.
Table 7-6.
Simultaneous ACL Activity Supported Per-Port
1
ACLs enhance network security by blocking selected IP traffic, and can serve
as one aspect of network security.
However, because ACLs do not protect from
malicious manipulation of data carried in IP packet transmissions, they
should not be relied upon for a complete edge security solution
.
Depending on the ACL configuration in the RADIUS server, the ACLs
described in this section filter either IPv4 traffic only or both IPv4 and IPv6
traffic. These ACLs
do not filter non-IP traffic
such as AppleTalk and IPX.
ACL Type
Function
IPv4
IPv6
VACL
Static ACL assignment to filter inbound IP
traffic on a specific VLAN.
1
1
Port ACL
Static ACL assignment to filter inbound IP
traffic on a specific port.
1
1
RADIUS-assigned ACL Dynamic ACL assignment to filter inbound IP
traffic from a specific client on a given port.
1-32
2
1-32
2
RACL (IPv4 only)
static ACL assignment to filter routed IPv4
traffic entering or leaving the switch on a
specific VLAN
1 in
1 out
n/a
Connection-Rate ACL
Static ACL assignment for virus-throttling on
a specific port. (Refer to chapter 3, “Virus
Throttling (Connection-Rate Filtering)” in this
manual.)
1
n/a
1
Subject to resource availability on the switch. For more information, refer to the appendix titled
“Monitoring Resources” in the latest
Management and Configuration Guide
for your switch.
2
One per authenticated client, up to a maximum of 32 clients per-port for 802.1X, Web-Authentication,
and MAC-Authentication methods combined.
Summary of Contents for HP ProCurve Series 6600
