HP G62 Series, Maintenance And Service Manual

Page: 71 / 135

Power button board
Description Spare part number
Power button board 606008-001
Before removing the power button board:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first disconnecting the power cord from the AC
outlet and then disconnecting the AC adapter from the computer.
4. Remove the battery (see Battery on page 41 ).
5. Remove the following components:
a. Hard drive (see Hard drive on page 42 )
b. Optical drive (see Optical drive on page 45 )
c. Keyboard (see Keyboard on page 53 )
d. Top cover (see Top cover on page 56 )
Remove the power button board:
1. Turn the top cover upside down with the rear edge toward you.
2. Remove the Phillips PM2.0×3.0 screw (1) that secures the power button board to the top cover.
3. Lift up and remove the power button board (2) .
Reverse this procedure to install the power button board.
Component replacement procedures 61