HP G3 KVM, User Manual

Page: 49 / 81

Using the on-board Web interface (OBWI) 49
6.
Click Download . The file downloads.
7.
Click Close .
Restoring a managed switch configuration or user database
To restore a KVM Console Switch configuration or local user database of a KVM Console Switch:
1.
Click Unit View>Appliance>Overview .
2.
Click Restore Appliance Configuration or Restore Appliance User Database .
3.
Select the file save method:
o
Filesystem
o
TFTP
o
FTP
o HTTP
4.
If you select Filesystem, click Browse to specify the location of the firmware upgrade file.
If you select TFTP, enter the server IP address and firmware filename to load.
If you select FTP or HTTP, enter the server IP address, username, password, and firmware filename
to load.
5.
Click
Browse
.
6.
Navigate to the location of the file, select the file, and then click Upload .
If the file is encrypted, enter the password.
7.
After the success screen appears, reboot the KVM Console Switch to enable the restored
configuration.
Identity and location information
The KVM Console Switch reports most device properties directly through the KVM Console Switch web
browser.
Clicking
Unit View>Appliance>Properties>Identity lists the part number, serial number, EID, and
status of the RAK.
Clicking
Unit View>Appliance>Properties>Location displays the site, department, and location. This
screen also displays the location discovery information, which is auto-populated when using a rackmount
console with HPE Location Discovery Services.
LDS and PDS
The KVM Console Switch supports PDS. When plugged into an iPDU using a PDS power cord, the iPDU
dynamically discovers the KVM Console Switch appliance.