433
Figure 475 PoE summary (with GigabitEthernet 1/0/3 selected)
PoE configuration example
Network requirements
As shown in
, GigabitEthernet 1/0/3 and GigabitEthernet 1/0/4 are connected to IP
telephones.
The IP telephones have a higher power supply priority than the AP so the PSE supplies power to the
IP telephones first if the PSE power is overloaded.
Figure 476 Network diagram
Configuring PoE
1.
Enable PoE on GigabitEthernet 1/0/3:
a.
Select
PoE
>
PoE
from the navigation tree.
b.
Click the
Setup
tab.
c.
On the tab, click to select ports GigabitEthernet 1/0/3 from the chassis front panel, and then
select
Enable
from the
Power State
list.
d.
Click
Apply
.
Summary of Contents for FlexNetwork NJ5000
