HP FlexNetwork NJ5000, User Manual

Page: 429 / 475

417
Table 154 Configuration items
Item Description
Please select a policy Select an existing policy in the list.
Direction
Set the direction in which the policy is to be applied.
•
Inbound
—Applies the policy to the incoming packets of the specified ports.
•
Outbound
—Applies the policy to the outgoing packets of the specified ports.
Please select port(s) Select one port to which the QoS policy is to be applied on the chassis front panel.
Configuring queue scheduling on a port
1.
Select
QoS
>
Queue
from the navigation tree.
2.
Click
Setup
to enter the queue scheduling configuration page.
Figure 454 Configuring queue scheduling
3.
Configure queue scheduling on a port as described in Table 155 .
4.
Click
Apply
.
Table 155 Configuration items
Item Description
WRR
Setup
WRR
Enable or disable the WRR queue scheduling mechanism on selected ports.
The following options are available:
•
Enable
—Enables WRR on selected ports.
•
Not Set
—Restores the default queuing algorithm on selected ports.
Queue
Select the queue to be configured.
The value range for a queue ID is 0 to 7.
Group
Specify the group the current queue is to be assigned to.
This list is available after you select a queue ID. The following groups are
available for selection:
•
SP
—Assigns a queue to the SP group.
•
1
—Assigns a queue to WRR group 1.
Weight
Set a weight for the current queue.
This list is available when group 1 is selected.
Please select port(s) Click to select ports to be configured with queuing on the chassis front panel.