HP FlexNetwork NJ5000, User Manual

Page: 314 / 475

302
Item Description
IMPORTANT:
When enabling the accounting-on feature on a device for the first time, you
must save the configuration so that the feature takes effect after the device
reboots.
Accounting-On Interval
Set the interval for sending accounting-on packets. This field is
configurable only after you select the
Send accounting-on packets
box.
Accounting-On Attempts
Set the maximum number of accounting-on packets transmission
attempts. This field is configurable only after you select the
Send
accounting-on packets
box.
Attribute
Interpretation
Enable or disable the device to interpret the RADIUS class attribute as
CAR parameters.
Adding RADIUS servers
1.
In the
RADIUS Server Configuration
area, click
Add
.
Figure 318 RADIUS server configuration page
2.
Configure the parameters, as described in Table 109 .
3.
Click
Apply
.
Table 109 Configuration items
Item Description
Server Type
Select the type of the RADIUS server to be configured. Options include primary
authentication server, primary accounting server, secondary authentication server, and
secondary accounting server.
IP Address
Specify the IPv4 or IPv6 address of the RADIUS server.
The IP addresses of the primary and secondary servers for a scheme must be different.
Otherwise, the configuration fails.
RADIUS server addresses in the same scheme must use the same IP version.
Port Specify the UDP port of the RADIUS server.
Key
Confirm Key
Specify the shared key for communication with the RADIUS server.
If no shared key is specified, the shared key specified in the common configuration part is
used.