248
5.
The destination device responds with an ICMP port-unreachable message because the packet
from the source has an unreachable port number. In this way, the source device gets the
address of the destination device.
In this way, the source device can get the addresses of all Layer 3 devices on the path.
Ping operation
Configuring IPv4 Ping
1.
Select
Network
>
Diagnostic
Tools
from the navigation tree.
2.
Click the
IPv4 Ping
tab.
The ping configuration page appears.
Figure 255 Ping configuration page
3.
Enter the IP address or the host name of the destination device in the
Destination IP address
or host name
field.
4.
Click
Start
.
The output is displayed in the
Summary
area.
Figure 256 IPv4 ping output
Summary of Contents for FlexNetwork NJ5000
