179
Views
System view
Predefined user roles
network-admin
Parameters
retries
: Specifies the maximum number of attempts for sending an authentication request to a client.
The value range is 1 to 10.
Usage guidelines
The access device retransmits an authentication request to a client in any of the following situations:
•
The device does not receive any responses from the client within the username request timeout
timer. The timer is set by using the
dot1x timer tx-period tx-period-value
command for the
EAP-Request/Identity packet.
•
The device does not receive any responses from the client within the client timeout timer. The
timer is set by using the
dot1x timer supp-timeout
supp-timeout-value
command for the
EAP-Request/MD5-Challenge packet.
The access device stops retransmitting the request, if it has made the maximum number of request
transmission attempts but still received no response.
Examples
# Set the maximum number of attempts to 9 for sending an authentication request to a client.
<Sysname> system-view
[Sysname] dot1x retry 9
Related commands
display dot1x
dot1x timer
dot1x smarton
Use
dot1x smarton
to enable the SmartOn feature on a port.
Use
undo dot1x smarton
to disable the SmartOn feature on a port.
Syntax
dot1x smarton
undo dot1x smarton
Default
The SmartOn feature is disabled on a port.
Views
Ethernet interface view
Predefined user roles
network-admin
Usage guidelines
The SmartOn feature and the online user handshake feature are mutually exclusive.
When a SmartOn-enabled port receives an EAPOL-Start packet from an 802.1X client, it sends a
unicast EAP-Request/Notification packet to the client. The client will respond with an
EAP-Response/Notification packet, which contains the SmartOn switch ID and the MD5 digest of the
Summary of Contents for FlexNetwork MSR Series
Page 1005: ...987 ...