•
57600
•
115200
The serial port configuration must be set to no parity, eight data bits, and one stop bit (N/8/1) for correct operation.
Set this value to match the serial port speed configured in the UEFI System Utilities.
Minimum Password Length
Specifies the minimum number of characters allowed when a user password is set or changed. The character length
must be a value from 0 to 39 characters long. The default value is 8.
Server Name
Enables you to specify the host server name. You can assign this value manually, but it might be overwritten by the
host software when the operating system loads.
• You can enter a server name that is up to 49 bytes.
• To force the browser to refresh and display the new value, save this setting, and then press
F5.
Server FQDN/IP Address
Enables you to specify the server FQDN or IP address. You can assign this value manually, but it might be overwritten
by the host software when the operating system loads.
• You can enter an FQDN or IP address that is up to 255 bytes.
• To force the browser to refresh and display the new value, save this setting, and then press
F5.
Authentication Failure Logging
Enables you to configure logging criteria for failed authentications. The following settings are valid:
•
Enabled-Every Failure—A failed login log entry is recorded after every failed login attempt.
•
Enabled-Every 2nd Failure—A failed login log entry is recorded after every second failed login attempt.
•
Enabled-Every 3rd Failure (default)—A failed login log entry is recorded after every third failed login attempt.
•
Enabled-Every 5th Failure—A failed login log entry is recorded after every fifth failed login attempt.
•
Disabled—No failed login log entry is recorded.
Authentication Failure Delay Time
Enables you to configure the duration of the iLO login delay after a failed login attempt. The following values are
valid: 2, 5, 10, and 30 seconds.
The default value is 10 seconds.
Authentication Failures Before Delay
Enables you to configure the number of failed login attempts that are allowed before iLO imposes a login delay. The
following values are valid: 1, 3, 5, or every failed login attempt.
The default setting is 1, which means that a login delay is not imposed until the second failed login attempt.
Configuring iLO access options
Prerequisites
Configure iLO Settings privilege
Set up HPE iLO on the HPE ProLiant e910t Server Blade
33
