To replace the component, reverse the removal procedure.
Removing and replacing the PCIe SFP+ riser card
About this task
The SFP+ riser card is supported only on the HPE Edgeline EL4000 Switch System.
Procedure
1.
on page 23).
2.
3.
Remove the access panel (
Removing the PCIe access panel
on page 23).
4.
Remove the left PCIe riser assembly (
Removing the left PCIe riser assembly
on page 26).
5.
Remove the right PCIe riser assembly (
Removing the right PCIe riser assembly
on page 27).
6.
Disconnect the SFP+ riser card cable from the baseboard.
7.
Using a Torx screwdriver, remove the two T-15 screws, and then remove the SFP+ riser card.
40
Removing and replacing the PCIe SFP+ riser card
Summary of Contents for Edgeline EL4000
Page 18: ...18 Customer self repair ...
Page 19: ...Customer self repair 19 ...
Page 20: ...20 Customer self repair ...
Page 65: ...wireless wide area network Acronyms and abbreviations 65 ...
