HP E4510-48G, Command Reference Manual

Page: 953 / 1334

1-4
z
The auto-execute command command may cause you unable to perform common configuration
in the user interface, so use it with caution.
z
Before executing the auto-execute command command and save your configuration, make sure
you can log into the switch in other modes and cancel the configuration.
Examples
# Configure the telnet 10.110.100.1 command to be executed automatically after users log into VTY 0.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface vty 0
[Sysname-ui-vty0] auto-execute command telnet 10.110.100.1
% This action will lead to configuration failure through ui-vty0. Are you sure?[Y/N]y
After the above configuration, when a user logs onto the device through VTY 0, the device
automatically executes the configured command and logs off the current user.
command accounting
Syntax
command accounting
undo command accounting
View
User interface view
Default Level
3: Manage level
Parameters
None
Description
Use the command accounting command to enable command accounting.
Use the undo command accounting command to restore the default.
By default, command accounting is disabled, that is, the accounting server does not record the
commands that the users executed.
If command accounting is enabled, every executed command will be recorded on the HWTACACS
server.
If both command accounting and command authorization are enabled, only the authorized and
executed commands will be recorded on the HWTACACS server.