HP E4510-48G, Command Reference Manual

Page: 95 / 1334

2-4
Bridge-Aggregation1 Load-Sharing Mode:
destination-mac address, source-mac address
# Display the link aggregation load sharing mode of each aggregation group.
<Sysname> display link-aggregation load-sharing mode interface
Bridge-Aggregation10 Load-Sharing Mode:
destination-ip address, source-ip address
Bridge-Aggregation20 Load-Sharing Mode:
Layer 2 traffic: destination-mac address, source-mac address
Layer 3 traffic: destination-ip address, source-ip address
Table 2-2 display link-aggregation load-sharing mode command output description
Field Description
Link-Aggregation Load-Sharing Mode
Displays the global link aggregation load sharing mode.
z
By default, the link aggregation load sharing modes
for Layer-2 traffic, and Layer-3 traffic displayed.
z
If you have configured a global load sharing mode,
the configured mode is displayed.
Layer 2 traffic: destination-mac address,
source-mac address
The default load sharing mode for Layer-2 traffic. In this
sample output, it is based on source MAC address and
destination MAC address.
Layer 3 traffic: destination-ip address,
source-ip address
The default load sharing mode for Layer-3 traffic. In this
sample output, it is based on source IP address and
destination IP address.
destination-mac address, source-mac
address
The user-configured link aggregation load sharing
mode. In this sample output, it is based on source MAC
address and destination MAC address.
display link-aggregation member-port
Syntax
display link-aggregation member-port [ interface-type interface-number [ to interface-type
interface-number ] ]
View
Any view
Default Level
1: Monitor level
Parameters
interface-type interface-number : Port type and port number.
to : Specifies an interface range in the form of interface-type interface-number to interface-type
interface-number , where the start interface number must be smaller than the end interface number.
Note that both the start interface and the end interface are inclusive.