HP E4510-48G, Command Reference Manual

Page: 860 / 1334

1-3
Field Description
State Port state: active or standby
Flush-count Number of transmitted flush messages
Last-flush-time
The time when the last flush message was transmitted (NA
indicates that no flush message has been transmitted)
flush enable
Syntax
flush enable [ control-vlan vlan-id ]
undo flush enable
View
Smart link group view
Default Level
2: System level
Parameters
control-vlan vlan-id : Specifies the control VLAN used for transmitting flush messages. The vlan-id
argument ranges from 1 to 4094.
Description
Use the flush enable command to enable flush update.
Use the undo flush enable command to disable flush update.
By default, flush update is enabled for smart link groups and VLAN 1 is used for flush message
transmission.
Note that, you need to configure different control VLANs for different smart link groups.
Related commands: smart-link flush enable .
Examples
# Disable flush update for smart link group 1.
<Sysname> system-view
[Sysname] smart-link group 1
[Sysname-smlk-group1] undo flush enable
port
Syntax
port interface-type interface-number { master | slave }
undo port interface-type interface-number
View
Smart link group view