HP E4510-48G, Command Reference Manual

Page: 707 / 1334

4-15
Parameters
max-retry-value : Maximum number of attempts to send an authentication request to a supplicant, in
the range 1 to 10.
Description
Use the dot1x retry command to set the maximum number of attempts to send an authentication
request to a supplicant.
Use the undo dot1x retry command to restore the default.
By default, the authenticator can send an authentication request to a supplicant twice at most.
Note that after sending an authentication request to a supplicant, the authenticator may retransmit the
request if it does not receive any response at an interval specified by the username request timeout
timer or supplicant timeout timer. The number of retransmission attempts is one less than the value set
by this command.
Related commands: display dot1x .
Examples
# Set the maximum number of attempts to send an authentication request to a supplicant as 9.
<Sysname> system-view
[Sysname] dot1x retry 9
dot1x timer
Syntax
dot1x timer { handshake-period handshake-period-value | quiet-period quiet-period-value |
reauth-period reauth-period-value | server-timeout server-timeout-value | supp-timeout
supp-timeout-value | tx-period tx-period-value }
undo dot1x timer { handshake-period | quiet-period | reauth-period | server-timeout |
supp-timeout | tx-period }
View
System view
Default Level
2: System level
Parameters
handshake-period-value : Setting for the handshake timer in seconds. It ranges from 5 to 1024 and
defaults to 15.
quiet-period-value : Setting for the quiet timer in seconds. It ranges from 10 to 120 and defaults to 60.
reauth-period-value : Setting for the periodic re-authentication timer in seconds. It ranges from 60 to
7200 and defaults to 3600.
server-timeout-value : Setting for the server timeout timer in seconds. It ranges from 100 to 300 and
defaults to 100.
supp-timeout-value : Setting for the supplicant timeout timer in seconds. It ranges from 1 to 120 and
defaults to 30.