HP E4510-48G, Command Reference Manual

Page: 702 / 1334

4-10
Default Level
2: System level
Parameters
user-number : Maximum number of users to be supported simultaneously. The valid settings and the
default may vary by device.
interface interface-list : Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list argument is in the format of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } & <1-10>, where interface-type represents the port type,
interface-number represents the port number, and & <1-10> means that you can provide up to 10 port
indexes/port index lists for this argument. The start port number must be smaller than the end number
and the two ports must be of the same type.
Description
Use the dot1x max-user command to set the maximum number of users to be supported
simultaneously for specified or all ports.
Use the undo dot1x max-user command to restore the default.
With no interface specified, the command sets the threshold for all ports.
Related commands: display dot1x .
Examples
# Set the maximum number of users for port GigabitEthernet 1/0/1 to support simultaneously as 32.
<Sysname> system-view
[Sysname] dot1x max-user 32 interface GigabitEthernet 1/0/1
Or
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] dot1x max-user 32
dot1x multicast-trigger
Syntax
dot1x multicast-trigger
undo dot1x multicast-trigger
View
Interface view
Default Level
2: System level
Parameters
None