5-1
5
RIPng Configuration Commands
The term “router” in this document refers to a router in a generic sense or a Layer 3 switch.
RIPng Configuration Commands
checkzero
Syntax
checkzero
undo checkzero
View
RIPng view
Default Level
2: System level
Parameters
None
Description
Use the
checkzero
command to enable the zero field check on RIPng packets.
Use the
undo checkzero
command to disable the zero field check.
The zero field check is enabled by default.
Some fields in RIPng packet headers must be zero. These fields are called zero fields. You can
enable the zero field check on RIPng packet headers. If any such field contains a non-zero value, the
RIPng packet will be discarded.
Examples
# Disable the zero field check on RIPng packet headers of RIPng 100.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100] undo checkzero
Summary of Contents for E4510-48G
