HP E4510-48G, Command Reference Manual

Page: 449 / 1334

3-15
View
RIP view
Default Level
2: System level
Parameters
route-policy-name : Routing policy name with 1 to 19 characters.
value : Priority for RIP route, in the range of 1 to 255. The smaller the value, the higher the priority.
Description
Use the preference command to specify the RIP route priority.
Use the undo preference route-policy command to restore the default.
By default, the priority of a RIP route is 100.
You can specify a routing policy using the keyword route-policy to set the specified priority to routes
matching the routing policy.
z
If a priority is set for matched routes in the routing policy, the priority applies to these routes. The
priority of other routes is the one set by the preference command.
z
If no priority is set for matched routes in the routing policy, the priority of all routes is the one set by
the preference command.
Examples
# Set the RIP route priority to 120.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] preference 120
reset rip statistics
Syntax
reset rip process-id statistics
View
User view
Default Level
2: System level
Parameters
process-id : RIP process ID, in the range of 1 to 65535.
Description
Use the reset rip statistics command to clear the statistics of the specified RIP process. This
command can be used to clear the statistics for debugging.