15-8
Parameters
-f first-ttl
: Specifies the first TTL, that is, the allowed number of hops for the first packet, in the range 1
to 255. It defaults to 1 and must be less than the maximum TTL.
-m max-ttl
: Specifies the maximum TTL, that is, the maximum allowed number of hops for a packet, in
the range 1 to 255. It defaults to 30 and must be greater than the first TTL.
-p port
: Specifies the UDP port number of the destination device, in the range 1 to 65535. The default
value is 33434. It is unnecessary to modify this parameter.
-q
packet-number
: Specifies the number of probe packets sent each time, in the range 1 to 65535,
defaulting to 3.
-w timeout
: Specifies the timeout time of the reply packet of a probe packet, in the range 1 to 65535, in
milliseconds. The default value is 5000 ms.
remote-system
: IPv6 address or host name of the destination device, a string of 1 to 46 characters.
Description
Use the
tracert
ipv6
command to view the path the IPv6 packets traverse from the source to the
destination device.
After having identified network failure with the
ping
command, you can use the
tracert
command to
determine the failed node(s).
Output information of the
tracert
ipv6
command includes IPv6 addresses of all the Layer 3 devices the
packets traverse from the source to the destination device. If a device times out, "* * *" will be
displayed.
During the execution of the command, you can press
Ctrl+C
to abort the tracert operation.
Examples
# View the path the packets traverse from the source to the destination with IPv6 address 3002::1.
<Sysname> tracert ipv6 3002::1
traceroute to 3002::1 30 hops max,60 bytes packet, press CTRL_C to break
1 3003::1 30 ms 10 ms 10 ms
2 3002::1 10 ms 11 ms 9 ms
For description on the fields in the above output information, refer to
.
System Debugging Commands
debugging
Syntax
debugging
{
all
[
timeout
time
] |
module-name
[
option
] }
undo
debugging
{
all
|
module-name
[
option
] }
View
User view
Default Level
1: Monitor level
Summary of Contents for E4510-48G
