10-15
z
Establish a connection, and the NMS can perform read and write operations to the MIB objects in
system view on the device
snmp-agent group
Syntax
The following syntax applies to SNMPv1 and SNMP v2c:
snmp-agent group
{
v1
|
v2c
}
group-name
[
read-view
read-view
] [
write-view
write-view
]
[
notify-view
notify-view
] [
acl
acl-number
]
undo
snmp-agent group
{
v1
|
v2c
}
group-name
The following syntax applies to SNMPv3:
snmp-agent group v3
group-name
[
authentication
|
privacy
] [
read-view
read-view
] [
write-view
write-view
] [
notify-view
notify-view
] [
acl
acl-number
]
undo
snmp-agent group
v3
group-name
[
authentication
|
privacy
]
View
System view
Default Level
3: Manage level
Parameters
v1
: SNMPv1.
v2c
: SNMPv2c.
v3
: SNMPv3.
group-name
: Group name, a string of 1 to 32 characters.
authentication
: Specifies the security model of the SNMP group to be authentication only (without
privacy).
privacy
: Specifies the security model of the SNMP group to be authentication and privacy.
read-view read-view
: Read view, a string of 1 to 32 characters. The default read view is ViewDefault.
write-view write-view:
Write view, a string of 1 to 32 characters. By default, no write view is configured,
namely, the NMS cannot perform the write operations to all MIB objects on the device.
notify-view notify-view
: Notify view, for sending traps, a string of 1 to 32 characters. By default, no
notify view is configured, namely, the agent does not send traps to the NMS.
acl
acl-number
: Associates a basic ACL with the group.
acl-number
is in the range 2000 to 2999. By
using a basic ACL, you can restrict the source IP address of SNMP packets, that is, you can configure
to allow or prohibit SNMP packets with a specific source IP address, so as to restrict the
intercommunication between the NMS and the agent.
Description
Use the
snmp-agent group
command to configure a new SNMP group and specify its access right.
Use the
undo
snmp-agent group
command to delete a specified SNMP group.
By default, SNMP groups configured by the
snmp-agent group
v3
command use a
no-authentication-no-privacy security model.
Summary of Contents for E4510-48G
