HP E3491A, Installation And Service Manual

Page: 59 / 70

R>? pv
pv - Execute the system performance verification diagnostics.
USAGE: pv <-l> <-t*|x[-y]> <-f> <-vverbose_level> <repeat_count>
pv - display pv warning message
pv <-l> - list pv test#s and descriptions only (do not execute)
pv <-t*|x[-y]> - select pv test number x or tests x thru y only
* selects all emulation tests
pv <-f> - for factory use only
pv <-vverbose> - set verbose level; valid levels: 1-9.
pv <repeat_count> - execute diagnostics (repeat_count> number of times.
repeat_count of 0 repeats until keyboard break
SETUP:
10BASE2 FEEDBACK TEST:
Disconnect 10Base2 Connector From the Network
Terminate With Two 50 Ohm Terminators on a TEE
10BASET FEEDBACK TEST:
Connect 10BaseT Connector To Active Port
Examples: To execute both tests one time:
pv 1
To execute test 2 with maximum debug output repeatedly until a ^C is
entered:
pv -t2 -v9 0
To execute tests 3, 4, and 5 only for 2 cycles:
pv -t3-5 2
Solving Problems
To execute the built-in performance verification test
51