HP E-MSM720, Reference Manual

Page: 204 / 244

CLI commands
Controlled APs network configuration context
2-154
sensor server id
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
sensor server id <id>
Sets the server ID of the RF Manager Server to connect to.
Parameters
ID
Specify the Server ID of the RF Manager Server to connect to. Set the
Server ID to 0 to have the controller send a discovery request to all active
HP RF Manager Servers. The controller will connect to the first server that
responds to the discovery request.
sensor discovery mode
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
sensor discovery mode (id | ip)
Sets the method the controller will use to communicate with the RF Manager Server.
Parameters
id
Connect using the Server ID of the RF Manager Server.
ip
Connect using the IP address or hostname of the RF Manager Server.
Description
For these methods to work, the following must be true:
„ The controller must be able to reach the RF Manager Server via a network connected to port 1
or port 2. For example, you should be able to ping the RF Manager Server’s IP address from
the controller.
„
If there are any firewalls between the controller and the RF Manager Server, then TCP and
UDP ports 3851 must be open bi-directionally.
„
If using the hostname option, an entry must be created on the network DNS server that points
to the IP address of the RF Manager Server.
„
If using the Server ID option, support for multicast traffic must be enabled on all routers and
switches connected between the controller and the RF Manager Server.
sensor network detector
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
sensor network detector
Enable the Network Detector.
no sensor network detector
Disable the Network Detector.
inherit sensor
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
inherit sensor
Inherit sensor settings from parent.