HP DESIGNJET 3D, Service Manual

Page: 362 / 458

-346
Figure 328: Measuring distances from outside edges of F and G
15. Measure and record the diameter of circle F along the center line
between E and G. See Figure 329
Figure 329: Measuring diameter of circle F
16. Add the lengths derived from steps 14 and 15 (E-F and F-G) and then
subtract the width of circle F derived from step 16. Record this total as
“GRear”
17. Measure and record the distance from the outside edges of circles C
and G. Ensure the caliper is not seated on the small bump of circles C or
G. Record this total as “GRight”, see Figure 330