Removing the Monitor Pedestal Base
You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm,
or other mounting fixture.
CAUTION:
Before beginning to disassemble the monitor, be sure the monitor is turned off and the
power and signal cables are disconnected. Also disconnect all USB cables connected to the monitor.
1.
Disconnect and remove the signal, power, and USB cables from the monitor.
2.
Lay the monitor face down on a flat surface covered by a clean, dry cloth.
3.
Pivot the base 45 degrees clockwise and remove the screw from the back of the monitor, then
pivot the base 45 degrees counter-clockwise and remove the other screw from the back of the
monitor.
Figure 3-11
Removing the Pedestal Base Screws
4.
Rotate the base of the monitor up (1) then pull it back (2) to unhinge the tabs on the monitor
stand from the slots in the monitor.
Figure 3-12
Removing the Pedestal Base
ENWW
Removing the Monitor Pedestal Base
13
Summary of Contents for Compaq LA2206xc
Page 1: ...HP Compaq LA2206xc Webcam LCD Monitor User Guide ...
Page 4: ...iv About This Guide ENWW ...
Page 8: ...viii ENWW ...
