HP-00007-01, Appendix 3 25-May-2005
HP Restricted
Page 2
2.0 Tools
Required
List the type and size of the tools that would typically be used to disassemble the product to a
point where components and materials requiring selective treatment can be removed.
Tool Description
Tool Size (if applicable)
Flat blade screwdriver
3.0 Product
Disassembly
Process
3.1
List the basic steps that should typically be followed to remove components and materials
requiring selective treatment:
SYSTEM BOARD
1
To remove the access panel, lift up on the access panel handle, slide the access panel
back about 2.5 cm (1 inch), and then lift it off the unit (see Figure 1 below).
2
Remove all cables from the computer.
3
To remove the system board (see Figure 2 below):
a) Compress the system board tray handle (1) to release the latch.
b) Slide the system board tray toward the front of the computer to free it from the back of
the chassis, and then lift the tray out of the computer (2).
BATTERY
Locate the battery and battery holder on the system board. Depending on the type of
battery holder on the system board, complete the following instructions to remove the
battery:
TYPE 1 BATTERY HOLDER
(see Figure 3 below)
Lift the battery out of the holder.
TYPE 2 BATTERY HOLDER
(see Figure 4 below)
To release the battery from its holder, squeeze the metal clamp that extends above one
edge of the battery. When the battery pops up, lift it out.
TYPE 3 BATTERY HOLDER
(see Figure 5 below)
Pull back on the clip that holds the battery in place, and then remove the battery.
