Connect the power cable
1.
Plug the power cable securely into the socket on the rear panel of the drive.
2.
Plug the other end of the power cable into the power outlet. The power on/off switch is on the
front panel, see Figure 14 (page 21).
Power cable
1
Power on/off switch
2
Figure 14 Connecting the power cable
Connecting an external SAS tape drive
This installation connects the tape drive directly to the external port.
If the server does not have an active external port, you must purchase and install an additional HBA
that supports external connection. If you are installing a new HBA, a spare PCI slot is required for
the new HBA.
WARNING!
Use of an unapproved power cord may result in: 1) not meeting individual country
specific safety requirements; 2) insufficient conductor ampacity that could result in overheating with
potential personal injury and/or property damage; and 3) an unapproved power cord could fracture
resulting in the internal contacts being exposed, which potentially could subject the user to a shock
hazard. The manufacturer disclaims all liability in the event an unapproved power cord is used.
NOTE:
If you use a recommended cable to attach directly to the external SAS port and the tape
drive does not function, one possible cause is that the port is inactive or not supported for external
tape devices. See your server documentation for information on supported configurations.
1.
If installing a new HBA, follow the instructions supplied with the HBA to install it and its driver.
Connecting an external SAS tape drive
21
