HP BL536A, User'S & Service Manual

Page: 72 / 165

2. Press Previous or Next until the screen displays Network Information . Press Enter to select.
3. Press Previous or Next to access the following information:
•
IPv4 Network Enabled or Disabled
•
IPv6 Network Enabled or Disabled
•
Host Name
•
Domain Name
•
MAC Address
4. For IPv4 Network or IPv6 Network, press Enter and then use Previous or Next to access the
network addresses and configuration.
Configuration
The Configuration menu provides access to the following configuration functions:
•
Changing the administrator password (Configuration > Change Admin Password) (page 72)
•
Setting the number of reserved slots (Configuration > Set Reserved Slot Count) (page 73)
•
Configuring the mailslot (Configuration > Configure Mailslot) (page 73)
•
Bar code reporting format (Configuration > Barcode Format Reporting) (page 73)
•
Changing the SCSI address — parallel SCSI devices (Configuration > Change Drive) (page 74)
•
Setting behaviors (Configuration > Autoloader Behavior) (page 74)
•
Setting the date and time (Configuration > Autoloader Date/Time) (page 75)
•
Configuring network settings (Configuration > Configure Network Settings) (page 75)
•
Configuring automatic cleaning (Configuration > Configure Auto Cleaning) (page 76)
•
Restoring factory defaults (Configuration > Restore Defaults) (page 77)
•
Saving and restoring the Autoloader configuration (Configuration > Save/Restore Configuration)
(page 77)
To access the Configuration menu:
1.
From the Home screen, press Previous or Next until the screen displays Configuration . Press
Enter to select.
2. Press Previous or Next until the screen displays your selected function. Press Enter to select.
Changing the administrator password (Configuration > Change Admin Password)
Use Change Admin Password to set or change the administrator password. Once the administrator
password is set, you must know the administrator password or the service password to change the
administrator password. Passwords consist of exactly eight numbers each between the values of
0 and 9.
Screens that require a password prompt for the password before allowing access to the restricted
areas. Once entered, the administrator password does not have to be entered a second time unless
there is no user activity for five minutes. Enter the administrator password if you are prompted to
do so.
To change the administrator password:
1.
From the Home screen, press Previous or Next until the screen displays Configuration . Press
Enter to select.
2. Press Previous or Next until the screen displays Change Admin Password . Press Enter to select.
3. The first number is flashing. Press Previous or Next to change the value of the flashing number.
When the flashing number shows the desired value, press Enter to select.
72 Operating the Tape Autoloader