HP BL536A, User'S & Service Manual

Page: 37 / 165

•
User — no password is required (leave the password box blank).
•
Administrator — the administrator password is required. The same administrator password is
used for the RMI and OCP. There is not a default administrator password; the administrator
password must be set with the OCP before it can be used with the RMI. If the administrator
password is lost, contact HP to generate a temporary password that will grant administrator
access.
•
Service — access to this level is by HP Service personnel only. The service password is set at
the factory. The same service password is used for the RMI and OCP.
The user login provides access to the Identity and Status options, but not the Configuration,
Operations, and Support options. Administrator level provides access to all screens except for the
Log configuration and HP Service screens.
TIP: By default, the administrator password is unset; all of the digits are null. You must set the
administrator password from the OCP to protect the administrator functions on the OCP and enable
the administrator functions in the RMI.
Status pane
The System Status pane (see Figure 24 (page 37) ) shows the current device and drive status.
Figure 24 System Status pane
The System Status pane displays the following:
•
Updated — the day, date, and time of the most recent status view. This timestamp comes from
your computer and may be different from the Autoloader Time at the bottom of the pane. Click
your browser's reload button to refresh the system status.
•
Status of the Autoloader and tape drive
The green Status Ok icon indicates that the device is fully operational and that no user intervention is
required.
The blue exclamation point Status Warning icon indicates that user attentionis necessary, but that the
device can still perform most operations.
The red X Status Error icon indicates that user intervention is required and that the device is not capable
of performing some operations.
•
Slots (Free/Total) — Free is the number of empty storage slots. Total is the number of storage
slots available to the host software, which does NOT include reserved slots.
•
Mailslot — shows whether the mailslot is open, closed, or disabled.
•
Autoloader Time — the date and time from the Autoloader, which can be set from the OCP
or RMI. The Autoloader Time is updated when the system status is refreshed. The time of the
most recent refresh is the Updated time at the top of the pane. If you call HP Service to request
a temporary administrator password, refresh the system status with your browser reload button
and then give the service engineer this Autoloader Time.
Remote management interface (RMI) 37